The frame is cut and assemble, as usual, to the appropirate
dimensions. Glass, backboard and mat boad is made to fit.

Spoons are laid out on mat board in the desired position. The mat board
is marked where the holder should be mounted.

A hole is drilled in the mouting board where the marks apear.

Post of the spoon holder is inserted into the whole from the front and
a speed nut is applied with the press-on tool.

Repeat steps 1-3 untill all holders are in place.

Trim off excess post from backside of mounting board.

Place spoons into holder in the desired position.

Glass is placed inside the frame. Spacers are added to create a shadowbox
to accommode the spoons between the glass and backboard.

Sawtooth hanger is attached for hanging. Turnbutton are used to fit
the backboard to allow ease of access to the spoons.